Locking plates engage a keyway in a shaft or adapter sleeve and are attached to the side face of the nut by two bolts secured with locking wire.
A locking plate consists of a plate, two hexagonal head bolts with drilled heads and lock wire to secure them
Spacers are the small parts inserted in-between the two bearings of your skate wheel axles. They take care of the coherence between the two bearings, in order to optimize the matching and synchronization of their rotation. The bearings lean on them when tightened. Locking Spacer,Bearing Locking Spacer,Locking Headset Spacer,Wheel Spacer Locking Ningbo Ritbearing Imp & Exp Co.,Ltd. , https://www.nbbearing.de
2. Place the transmission lever in the neutral position of the low gear area;
3ã€Disengage the clutch, first connect the power switch, then connect the parking power switch;
At this time, the multi-function buzzer will sound an alarm;
4. According to the use requirements, place the transmission joystick in the required gear position (below 3rd gear) in the low gear area, slowly release the clutch pedal, the power take-off device enters the working state, the power take off indicator light is on, and the oil pump in the hydraulic system is It is in working condition. At this time, be careful not to bang the throttle and keep the engine speed at 1000-1600 rpm.
5. When the power take-off is needed to stop working, step on the clutch pedal, put the gear lever on the neutral position, press the power switch and parking power switch to the off position, the power take off light is off, multi-function buzzer The device stops alarming and finally releases the clutch pedal.
The most common model is shown on the 3D diagram below (in blue): a floating collar spacer with an axle of 8 mm.
Dump semitrailer operation
Take part of the power operation 1, first confirm that the engine is working properly, and ensure that the system air pressure is 700 ~ 800KPa;