September 5, CGNPC wind power company professional and technical personnel acceptance, Rudong 150 MW offshore wind power demonstration project successfully hoisted the first wind turbine, "sucked God" stand in the choppy Yellow Sea. CGN Rudong 150 MW offshore wind power demonstration project is the first offshore wind power project in China, located within 25-35 km of Yangkou Port in the blue ocean area. May 23 this year, the project successfully sank the first pile, is expected to be completed by the end of November, all the amount of pile driving projects. In the offshore area far away from the sea, silt layer, clay layer, silt layer geological complex structure, unpredictable sea climate changes, the three cross-aircraft construction of innovative technology, the first time in the country using the "jacket stabilized pile platform" for homework The height of the jacket was 17 meters. The jacket was placed in the silt layer, and 4 piles were set at 4 corners to weld and fix the jacket. "Europe offshore sink pile support vessel operations, only one sinking 10 piles a year, our steady pile platform can be completed every month sinking pile 10 to 10, and the vertical accuracy of control in less than three thousandths, Operation cycle is greatly shortened. "Bearing the task of sinking the construction of the three cross-Eastern Air, such as Dongfeng Electric project manager told reporters. At 10:18 on September 2, CGNPC general manager Li Hyeon-lun instructed on an auto-lift platform through a walkie-talkie: "The first wind turbine hoist at the CGN Rudong 150MW offshore wind farm demonstration project" 12,000 tons of transport barge on the slowly rising, accurate docking to the foundation of the offshore wind turbine flange, fastening, the use of special spreader single-blade installation technology, one after another for each of up to 63 meters, weighing 13 tons of 3 Blade leaves hoisted in place. After repeated testing, 3, to complete the installation of all workload. It is understood that China Guangdong Nuclear Rudong 150 MW offshore wind farm plans to install 38 4 MW wind turbines installed capacity of 152 MW, the annual power generation capacity of 388 million kwh. The successful hoisting of the first wind turbine marks a breakthrough for China Guangdong Nuclear Power Corporation to achieve zero offshore wind power and a demonstration for China's wind power project to enter the deep blue water area.
In the CNC machining industry, in addition to metal CNC machining, plastic CNC machining is also relatively common. The two are also very different in terms of machining, the selected tools are also different, and there are also essential differences in speed and cooling. Due to the internal stress of the plastic, it is easy to crack and deform, so in the process of processing, it is necessary to control the speed of the tool and the problems of cooling. In short, CNC machining of metal parts and plastic parts is essentially different in the selection of tools, programming of tool paths, determination of tool speed and determination of cooling schemes. It is necessary to fully select and design materials according to material characteristics and processing experience. Only by determining various factors can we produce efficient and qualified products.
Machining metal parts and machining plastic parts are two separate departments at SCZY, each with its own processing equipment, tools and processing technicians. This ensures the durability of the equipment and the experience and professionalism of the technicians. Please contact us to discuss CNC machining knowledge.
Plastic CNC Machining, Machining Of Plastic Parts, Plastic Machining Parts, CNC Plastic, Plastic Precision, Plastic Part,CNC Machining for Plastic Shenzhen SCZY Technology Co.,Ltd , https://www.szcasting.com