Although the R&D technology of the car is already relatively strong, some parts and components are still inevitably replaced. Take the car's fuses, the circuit of a typical vehicle has gone through detailed experiments at the factory or even at the beginning of design. It should be no problem, but why does the vehicle fuse break down? Some industry insiders have investigated this issue and consulted with some maintenance experts and conversion experts. The conclusions are as follows: At present, there are two main reasons for the breakdown of automotive fuses on the market. One is that the electrical load is too large; the other is a short circuit in the car circuit. The main reasons for the excessive use of electrical appliances are: changing the headlights, car audio equipment, using poor-quality cigarette lighter adapters, and using high-power electrical appliances to connect cigarette lighters. Therefore, to remind all owners to understand the power and the maximum load of the car's original appliance before changing the circuit of the car. For example, if the wattage of the modified headlight is higher than the original set value, it may cause the fuse of the lamp to break down. If the car's appliance has not been modified and there is a broken fuse, you need to check whether the car's circuit is short-circuited. In the daily maintenance, not flushing the engine compartment directly with hoses is a good habit to avoid short-circuiting of the fuse box and the line; in addition, it can be observed by visual observation whether there is a wire short-circuited due to the aging of the wire rubber aging; in addition, when carrying out cleaning in the vehicle, it should also be Take care not to touch the wires buried in the floor. Another thing to note is that do not press the glass for a long time, otherwise it will cause the fuse to break. Especially in the winter, some car owners may have forgotten to replace the glass water with anti-freeze function. However, when glass water was sprayed in the morning, it was found that the water was not sprayed but was always pressed by the glass water switch. The water pump fuse that controls the glass water spray will be broken due to overheating, and the water pump will be burned when serious. If you encounter such a situation that the switch does not spray water, you do not worry to continue to press the spray switch, you should get off to check whether the glass water is frozen, or to see if the spout is blocked. The fuse damage problem can be very small or small, so owners should pay attention to using the car at ordinary times, and try hard to modify some of the equipment with larger loads. Basic Features:
Starch glue for corrugated board is an adhesive made of natural raw materials, non-toxic, odorless, formaldehyde-free and environmentally friendly. It replaces pure starch and starch with various additives.
Physical characteristics:
Scope of application:
Starch Glue For Corrugated,Glue Powder For Corrugated,Corn Starch Glue,Modified Starch Zhengzhou Enlin Import And Export Trade Co., Ltd , https://www.enlintrade.com
Containing a variety of organic and inorganic ingredients, PH value shows alkaline, easily soluble in water, caustic soda and Borax can make it gelatinized into a high-viscosity gel.
Features:
1. The gelatinization temperature (gelatinization point) is low: 4-7 degrees lower than ordinary starch, at the same temperature, the boot speed can be increased.
2. Firm adhesion: The adhesiveness is far better than pure corn starch and corn starch with various additives.
3. High cost performance: The dosage is 80% of pure starch, and the cost is greatly reduced.
4. The cardboard is stiff: the film has high hardness, and the flat pressure and underside strength of the glued cardboard are obviously improved. The edge pressure strength is increased by more than 10%, which fully meets or exceeds the strength of starch and additive glue.
5. Good moisture resistance: The glue has also undergone moisture resistance treatment, which can better meet the needs of moisture resistance and strong strength of the carton in a moisture resistance environment.
6. Green and environmental protection: long-term use of the starch glue is harmless to the human body, and the product production conforms to the ISO9001 enterprise production system.
1. Mainly suitable for single-sided machines and domestic and imported automated cardboard production lines.
2. It is suitable for three, four, five, seven and nine layers of cardboard.
