When a special vehicle is started, the following conditions are most likely to occur. Hereafter, we will use a compression garbage truck as an example to introduce solutions to several common problems. The cause of the accident and its solution: The starter brush of the compression type garbage truck is loosely connected to the battery rectifier battery or the power storage is insufficient. When the storage capacity of the battery is insufficient, the rotational speed of the starter may be insufficient, so that it is difficult for the compression type garbage dump engine to reach the required rotation speed at the time of start-up, resulting in difficulty in ignition. Therefore, when the battery of the compact garbage truck is not enough, it must be charged in time. The driver's friends should also check the wiring of the compression garbage truck in due course. If the wiring is loose, tighten the cable in time, and the bad contact or premature circuit connection will lead to the top teeth; when the electromagnetic circuit fails, the start-up opportunities will idle and the gears will not mesh. Can not drive the compression garbage truck engine running. At this time, if the line is overhauled, the eccentric shaft below the electromagnetic switch of the starter must be adjusted, if necessary, so that the distance of the ring gear is appropriate. The compact garbage truck's battery should be packed compactly. If the brush is in poor contact, sparks will be emitted at loose joints at the start. Therefore, it is necessary to check the surface of the commutator in a timely manner. If uneven or loose phenomenon occurs, it is necessary to grind or replace the brush. When the cold garbage truck is started in cold weather, it is necessary to heat the radiator and warm the oil. X56 Ssaw Pipe,Api X56 Ssaw Pipe,Api Spiral Steel Pipe Hydrogrand Steel Pipe Co.,ltd , https://www.hydrograndtube.com
When the compression type garbage truck is started, the engine speed of the compression type garbage truck is too low